Calibration value after screwing the tightener regulator lock screw

[isiora]

Hi Elite,

I started the calibration procedure of my Direto because the offset dropped more than 5 points (6503 vs 6509, the value stamped on the sticker).
I had no problem to execute the procedure and to reach to original offset value again, until I screw the lock of the tightener regulator. After this action, the offset value dropped from 6509 to 6505. I repeated the procedure, but I had same result.
What I must do? Do I have I to make sure that the offset value is 6509 after screwing the lock, or no?

Thanks in advance.

[Elite Admin S]

The value must be the same of the original one AFTER you close the lock

Regards

[Elite Admin S]

The value must be the same of the original one AFTER you close the lock

Regards

[danga]

The value must be the same of the original one AFTER you close the lock

Regards

Support has advised it should be within 5 from the factory value? So which is it? Exact value or within 5 of the factory offset?

Thanks
David